1996 Cape George Marine Works Cape George Cutter located in Washington for sale

36' Cape George Marine Works Cape George Cutter

Year
Length
Beam
Draft
Location
Price
1996
36'
10.75'
5'
Washington
$45,000

Description: 80% COMPLETE CAPE GEORGE CUTTER
PEARL
Hull by Cecil M. Lange, 36' fiber glass. Deck and cabin beams are yellow cedar. Deck 3/8" sapele mahogany plywood with second layer 3/8" fir, cabin top is the same as deck material, two layers are 1/4". ALL SAPELE MAHOGANY is LYODDS of LONDON CERTIFIED. Cabin sides are 1" thick Fir Plywood. Deck, cabin sides and top are all fiber glassed over. Laminate schedule is matt/ 2 rovings/matt. Cecil M. Lange did the water and diesel tanks, he also made the teak hatches: forward hatch, skylight, turtle/companionway hatch, and two aft lazerett hatches. Doug Mosen - Boat Electrician, did most of the electrical design in conjunction with me. Cecil advised me and went beyond that by coming over from Port Townsend for dinner and in person advise. He stated at the launching that Pearl was one of the two best built boats outside of his yard.
Hull#: CMKOO114G688
Dimensions: length 36 breadth 10 5 draft 5
Capacities: Fuel 85 gallons in two fiber glass tanks @ 42.5 gallons each
Freshwater 100 gallons in two fiber glass tanks @ 50 gallons
Ballast: 10,500 pounds of lead
Horsepower: 36 @ 3000 rpm
General Description:
This vessel is an all Fiber Glass constructed Sail Boat.
The interior sides are 2 wide by Port Orford Cedar strips.
The interior decks are 2 Honduras Mahogany strips separated by Port Orford strips.
All other interior wood is Sepely Mahogany plywood.
All exterior wood is Burmese Teak.
The hull has 6 Sea Cocks, all are Bronze ball valves with a stainless steel ball and nylon seat.
There is berthing for 5 persons with a sink, shower and toilet facilities.
The galley has a 2 burner propane stove with oven, S/S sink, 5.2 cu. ft. refrigerator and a 5.2 cu. ft. freezer.
The vessels auxiliary power is a 36 Hp. 4 cylinder Demler Benz 0m536 engine attached to 2.04:1 Paragon P23L reduction gears driving a 1 1/8 SS shaft.
Average speed is 6 knots

Equipment: NAVIGATION AND COMMUNICATIONS EQUIPMENT
Auto Pilot Autohelm ST-50 with a speed and depth log

MISCELLANEOUS EQUIPMENT AND MACNINERY
Hot water heater Walter, propane flash heater
Stove Princess 2 burner with oven
Refrigerator 5.2 cu. ft., 12 volt dc only
Freezer 5.2 cu. ft., 12 volt dc only
Marine Sanitation type 1 electra san with a 30 gallon holding tank
Fresh water pump 1 electric
Batteries (2) 8-D
Battery Charger inverter
Inverter Trace
Shore Tie 110 VAC, 30 AMP
DECK GEAR
Anchor Windlass manual
Anchor 44# bruce
Rails 30 S/S
Cleats (3) 12 cleats
WAY TOO MUCH TO DESCRIBE> THE BOAT WAS BUILT WITH ALOT OF FORESIGHT, HIGHEST QUALITY WORK and SHE IS BUILT FOR OFFSHORE WORK!!!!!!!!


OTHER RANDOM NOTES
Boat also has an isolation transformer on it which magnetically isolates the shore power(110V) from a hard wired-like connection. Yeah the boat is one of a kind..............All my exterior hardware is of high Quality. Wherever ANY fasteners penetrated Hull/Deck or Cabin Top I chamfer as to create a kind of O-ring which few people take the time to do. This decreases the possibility of water penetration. Custom made coil spring mattress. Engine only has 20-30 hrs on it. The freezer and refrigeration are not completely finished but includes everything to finish it. She still needs the mast and rigging. She was launched in 97 I believe and was lived aboard for a few years and then the project was dropped. The Hull is insulated with 3/8' (I believe it's called ) Klegacell (sp?) That's a cool feature for two reasons 1. Cuts down on inside sweating and 2. It makes the boat overall stronger because it super-reinforces the bulkwarks (sp?) This would be an amazing vessel for someone who wants to finish her off.

Location: Everett, Washington
L15552
509-885-7540

Material
Hull
Type
Rigging
Cabins
Condition
fiberglass
monohull
daysailer
other
good

Click on any thumbnail below for a larger photograph, or View All Photographs Inline

The URL for this page is www.sailboatlistings.com/view/15552

This Cape George Marine Works Cape George Cutter Added 13-Dec-2009



Cape George Marine Works Cape George Cutter Click to launch Larger Image Cape George Marine Works Cape George Cutter Click to launch Larger Image Cape George Marine Works Cape George Cutter Click to launch Larger Image Cape George Marine Works Cape George Cutter Click to launch Larger Image Cape George Marine Works Cape George Cutter Click to launch Larger Image Cape George Marine Works Cape George Cutter Click to launch Larger Image






 
 



Allied | Allmand | Alubat | Amel | AMF | Bavaria | Bayfield | Beneteau | Bristol | Bruce Roberts | Cabo Rico | Cal | Canadian Sailcraft | Cape Dory | Capital Yachts | Catalina | CE Ryder | C&C | Cheoy Lee | Columbia | Com-pac | Coronado | Corsair | CSY | Dufour | Elan | Endeavour | Ericson | Formosa | Fountaine Pajot | Freedom | General Boats | Gozzard | Gulfstar | Hake / Seaward | Hallberg Rassy | Hans Christian | Hardin | Hobie | Hinckley | Hinterhoeller | Hunter | Hutchins | Hylas | Irwin | Island Packet | Islander | Jeanneau | Jensen | J Boats | Lagoon | Lancer | Macgregor | Moody | Morgan | Nauticat | O'Day | Pacific Seacraft | Pearson | Performance Cruising | Precision | Privilege | Ranger | S2 | Sabre | San Juan | Seidelmann | Shannon | Skookum | Southern Cross | Soverel | Sparkman & Stephens | Tanzer | Tartan | Tayana | Valiant | Vanguard | Voyage | Watkins | Wauquiez | West Wight Potter | Wharram | Whitby
Show all sailboats for sale under: 15 20 25 30 35 40 45 50 55 60 70 80 (feet LOA) | Multihulls: Catamarans Trimarans