170' 3 Masted Schooner

Year	Length	Beam	Draft	Location	Price
	170'	'	'	Connecticut	$2,000,000

Description:

This vessel is located in the NorthEast United States. ***********PRICE REDUCED AGAIN************* OWNER WANTS HER SOLD She was custom designed to fulfill all USCG and SOLAS requirements to carry passengers on oceans. The Certificate of Inspection has currently lapsed. She was recently audioguaged (Planemetrics 37DLPlus) in various areas as a source of additional information of steel condition. Steel was found to have some surface rust in exposed areas where coatings had been poorly or thinly applied- edges etc but overall was well coated and even where thin rusting had taken place, underlying steel was measured "as built" The engine is a Lugger 6140 Diesel with less than 2300 hours. 6 cylinder, 500HP. A unique feature of this unique vessel is the ability to cruise in much shallower waters than just about anything else of this size due to the centerboard design. With the centerboard down she draws 19', but in the up position only 10'. A great advantage when cruising the islands. There is an extensive inventory that comes with this vessel with a full complement of sails, life jackets, lafe saving equipment, and every amenity you would expect on a relatively new passenger carrying vessel of this size. Make sure to view the video at www.ruddersandmoorings.com for a virtual tour, and contact us to arrange for a personal inspection.

Equipment:

Electrical System Two 55 kw Northern Lights Diesel Generators 110, 220, 12-volt Batteries House: 110/220 V Shore :100 A, three phase, 4 wire 2 water makers Electronics/Navigation Equipment Ritchie Compass, 8" Standard VHF Wind Indicator Radar - Furuno 1832 Echo sounder Radar reflector SSB Safety/Required Equipment/Surveyor Notes PFD's: USCG Type I (33 USC 175) VDS: Solas standard (33 USC 175) Bell: Trumpet and Handheld freon Fire Extinguishers: 7 total Fixed Fire System: Kidde CO2 Life jackets, safety harnesses EPIRB, liferings flares Rigging/Sails 13 Sails 8500 square-foot sail area Standing Rigging: galvanized wire Turnbuckles: Galvanized Chainplates: Steel Running Rigging: Polyester three strand Deck Equipment Anchor: 1,000lbs fisherman and 1,00lbs stockless Chain/Rode: Bulwarks: Steel Docklines: Misc 3-strand Boats: (1) Zodiac-Pro7 w/40hp Evinrude Deck - Teak over plywood over steel Cabin Sole - Steel Hull/Deck Joint: Welded Mechanical Equipment/Engine Details/Propulsion System Single Screw 500 hp Diesel, Lugger Heat exchanged Reduction Gear: "ZF" 2:1 ratio 3 Blade fixed 64" Propeller Cutlass Bearing 4" Stainless Steel Shaft Stuffing Box: Traditional w/water injected log Galley equipment Garland Heavy Duty 10-Burner Electric Restaurant Range 2 @ 26” x 26” ovens 3-door commercial true refrigerator microwave deep freezing system miscellaneous cooking and bedding

Location: , Connecticut

L30797

401-338-3554 Contact Seller

Material	Hull	Type	Rigging	Cabins	Condition
fiberglass	monohull	cruiser			good