SailboatListings.com


1980  Rafiki Offshore Cutter located in Florida for sale

37' Rafiki Offshore Cutter

Year
Length
Beam
Draft
Location
Price
1980
37'
12'
6'
Florida
$20,000

Description: This Rafiki will take you anywhere in the world. It was built with many custom ordered features and upgrades. She was designed for blue oceans and distant shores. A seaworthy stable platform indeed. A rare timeless beauty with great lines. With a little coin and a lot of sweat equity this boat will endure for another 40 years.
If your looking for a comfortable cruiser at a reasonable price then look no further. Her interior is well laid out for living aboard with plenty of space and storage. Tons of custom teak inside and out. Heavy duty rigging, winches, deck hardware throughout. This vessel checks off many seaworthy attributes on the list one looks for in a prospective blue water cruising vessel.
She is currently in the water and running great. Powered with a marinized Isuzu C240/QD 60HP that starts right up. Parts easily available online.
The galley has deep double stainless steel sinks, a Seaward 2 burner gimbal stove with oven connected to an aluminum 5 gallon LPG tank on deck with shutoff valve. New freshwater pump with pressure sensor installed for galley sink.
The saloon table folds down to make a double berth. The settee across pulls out with legs attached to make a large single. The forward cabin is equipped with a double as well as a single quarter berth aft.
This boat offers great potential for the mechanically inclined. She will need a substantial amount of work and investment to reach cruise ready status again.
Projects in need of address
Teak decks will need repaired or removed.
The fuel tanks have not been used in years for reasons unknown. There is a 5 gallon jerry can system as a temporary setup.
Will need new rigging in the immediate future. Currently missing the furthest aft lower shrouds on port and starboard.
The head is not finished. There is a new Jabsco manual pump and flush with a 20 gallon holding tank installed. The sink, shower, and cabinetry will need to be built and completed.
There is substantial hard marine growth on the outside of of the hull. She will need a haul out and a new coat of paint.

Equipment: Cutter Rigged
Long full keel with transom hung rudder and tiller
LOA 36.75 ft.
LWL 32 ft.
Beam 11.97 ft.
Sail Area 729 ft.
Draft 6 ft.
Displacement 26,500 lbs.
Ballast 11,500 lbs.
2 Diesel tanks. Fiberglassed over. 125 gallons total
2 Steel water tanks. 195 gallons total.
Interior cabin height 6 ft. 4 in.
Cruising speed 7 knots
Year built: 1980
Builder: Pacific Yacht Crafters/ Lien Hwa, Taiwan
Designer: Stan Huntingford
Isuzu C240/QD60, 60 HP 4 cylinder marine diesel engine with manuals and parts catalogs. Hours unknown. New impeller, alternator, and hosing. Fluids and filters recently changed. Hooked up to rotating Max Prop.
Equipment:
Heavy Duty double anchor bow roller
45# CQR
35# Danforth
35# Bruce
Maxwell 2200 electric windlass in need of new motor
150 ft. 3/8 chain
Lots of various extra anchor/dock lines and fenders
2 Barient 27 2spd self-tailing jib winches
1 Barient 19 2spd self-tailing, 1 Barient 10 single speed self-tailing winch on cabin top
1 Barient 12 2spd self-tailing, 1 Barient 18 single speed, and 1 Barient 10 single speed winch on mast
1 Barient 10 single speed winch on boom
Merriman snatch blocks
All head sails designed for use with Harken roller furling system
Main sail, in good condition
120% jib, in good condition
75% yankee, in good condition
Staysail, in fair condition
Storm sail, in good condition
Stack pack with lazy jacks, in fair condition
Mast, boom, staysail boom, all in good condition
Spinnaker pole, attached to mast for storage
Monitor wind vane, needs repaired, parts on board
Alpha marine systems auto pilot, uninstalled
Standard Horizon CP190i chart plotter
Sea 222 single sideband with tuner, untested
Tank Tender fuel gauges, untested
LPG safety control system
Heavy duty bronze seacocks, needs serviced
2 100 watt solar panels, 200W total
4 US 2200 XC2 6V deep cycle golf cart batteries wired in series/parallel; 464 amps
15 opening ports and 2 hatches, all have screens with exception of only 1
Includes 10 ft. Achilles Hypalon inflatable with Mercury 3.5 hp outboard, includes bimini top and oars.

Location: Marathon, Florida
L87226
(907) 654-5604

Material
Hull
Type
Rigging
Cabins
Condition
fiberglass
monohull
cruiser
cutter
1
project boat

Click on any thumbnail below for a larger photograph, or View All Photographs Inline

The URL for this page is www.sailboatlistings.com/view/87226

Featured Sailboat Added 31-Jul-2020



 Rafiki Offshore Cutter Click to launch Larger Image  Rafiki Offshore Cutter Click to launch Larger Image  Rafiki Offshore Cutter Click to launch Larger Image  Rafiki Offshore Cutter Click to launch Larger Image  Rafiki Offshore Cutter Click to launch Larger Image  Rafiki Offshore Cutter Click to launch Larger Image  Rafiki Offshore Cutter Click to launch Larger Image  Rafiki Offshore Cutter Click to launch Larger Image  Rafiki Offshore Cutter Click to launch Larger Image  Rafiki Offshore Cutter Click to launch Larger Image  Rafiki Offshore Cutter Click to launch Larger Image  Rafiki Offshore Cutter Click to launch Larger Image  Rafiki Offshore Cutter Click to launch Larger Image  Rafiki Offshore Cutter Click to launch Larger Image  Rafiki Offshore Cutter Click to launch Larger Image

Show all sailboats for sale under: 15 20 25 30 35 40 45 50 55 60 70 80 (feet LOA) | Multihulls: Catamarans Trimarans