SailboatListings.com


2006 The Apprenticeshop 2006 18Ft Fenwick Williams Catboat located in Michigan for sale

18' The Apprenticeshop 2006 18Ft Fenwick Williams Catboat



Year
Length
Beam
Draft
Location
Price
2006
18'
8'6'
4'6'
Michigan
$69,000

Description:
Price: $ 69,900.00
Description:
Boat Name
PALOMA
Specs
Builder: The Apprenticeshop
Designer: Fenwick Williams
Keel: CenterboardDimensions
LOA: 18 ft 0 in
Beam: 8 ft 6 in
LWL: 17 ft 6 in
Length on Deck: 18 ft 0 in
Minimum Draft: 2 ft 0 in
Maximum Draft: 4 ft 6 in
Dry Weight: 3763 lbsEngines
Total Power: 10 HPEngine 1:
Engine Brand: Yanmar
Engine Model: 1GM10
Engine Type: Inboard
Engine/Fuel Type: Diesel
Drive Type: Direct Drive
Engine Power: 10 HPCurrent Price: $69,900This beautiful and traditional Cape Cod Catboat from the dean of catboat designers, with her shallow draft, stiffness under sail, and overall roominess, could be just the pocket-cruiser you've been looking for. At 18, this shallow-draft weekend cruiser was designed by the renowned catboat designer Fenwick Williams and built over 2 years by the Apprentice Shop in Rockland, Maine.Hand built with the finest woods throughout: Teak, Northern White Cedar, Mahogany, Spruce, Sitka Spruce and African Bubinga can be found in the deck, seats, centerboard trunk, table, wheel and cabin. The hull construction is cedar planking on oak frames.General Details; Carved-planked traditional construction. She's a centerboard boat with a 2' draft board up. Board down, 4'6"

Equipment:
Rigs and Sails Sail area: 310 sq ft. Rig: Traditional Gaff-rigged cat Spars Mast: Hollow, laminated spruce Boom: Spruce Gaff: Sitka spruce Spar jaws: Teak Mast hoops: White oak with copper rivets Sails: Oceanus sails sewn by: Gambell & Hunter Sailmaker Camden Maine



This husky, round-bottomed centerboard cruiser has cruising accommodations for two, a 10hp Yanmar 1GM10 diesel engine with only 12 hours, and a custom Load-Rite double-axle trailer.

Located in Northport Point, Michigan, this boat is in very good condition and systems are working well, according to her owner.

Rigging and Hardware: Custom bronze hardware forged by: Auburn Stove Foundry Co. New Gloucester, ME Tabernacle and traveler built by: Bill Lowe System Specifications; Engine: 10 hp Yanmar Diesel, 1GM10 Drive system: 1" standard shaft (H&H Propeller) Bearings: Standard interior stuffing box with exterior cutlass bearing Propeller: 13.8" 3 blade Steering system: Vetus hydraulic system Rudder: White oak Fuel: 5 gallons, polyethylene tank Battery: Group 24 sealed deep cycle marine battery Battery switch: Perko Multi Bilge pump: Rule 1100 automatic: RM 1100, 12V, 11/8" discharge Running lights: Antique running lights Masthead light: 360 Custom Throttle/shift: Vetus

Construction details; Keel, stem, dead wood and transom: White Oak Frames: Steam Bent White Oak Planking: Northern White Cedar Toe rails: Teak Deck beams: White Oak Deck: Laid Teak Cabin top beams: Laminated Mahogany Sole: Teak Chain locker bulkhead: Northern White Cedar & Okoume plywood Main bulkhead: Northern White Cedar & Okoume Cabin top: Okoume plywood with dynel & Northern White Cedar

Fastenings: Copper and Silicon Bronze Hardware: Bronze Centerboard: White Oak Centerboard trunk: White oak, Northern White Cedar, & Teak

Additional features; Galley sink (approx: 12" diameter, stainless steel) with Iynspray Ws-62" galley pump. The pump is BRASS and manufactured in New Zealand. Galley stove (alcohol) by Origo of Sweden with 2 burners. Removable porta-potty housed in a custom built, wooden locker within the cabin. Custom cushions to fit the 7' berths. Tandem, double axle "Load Rite" trailer. The trailer was custom made for the boat and has surge brakes with a new, heavy duty trailer jack (2010). Tan canvas sail covers with separate tan canvas "bimini" cockpit cover to protect her while docked. Light green, canvas boat cover for winter storage. Separate anchor in canvas sailbag for easier transport.

Information On Condition

Her proud owner says she is in excellent condition and is stored covered inside with care. All Sails, Rigging and the Trailer as stated by her owner are in excellent condition. Please see, the photos!

**CONTACT**

Glenn Schroeder

Barnegat Bay Yacht Brokerage

609-312-8263

HeartsDesire1925@gmail.com

WEBSITE: https://boatnation.com/list/profile/boats-sale-used-new/classic-wooden-and-fiberglass-boats/barnegat-bay-yacht-brokerage-2/

**THE "CLASSICS "ARE WHAT WE SELL**

Thank you, Glenn Schroeder

Location: Northport Point, Michigan
L88168
609-312-8263

Material
Hull
Type
Rigging
Cabins
Condition
wood
monohull
cruiser
cat boat
1
excellent

Click on any thumbnail below for a larger photograph, or View All Photographs Inline

The URL for this page is www.sailboatlistings.com/view/88168

This The Apprenticeshop 2006 18Ft Fenwick Williams Catboat Added 10-Sep-2020



The Apprenticeshop 2006 18Ft Fenwick Williams Catboat Click to launch Larger Image The Apprenticeshop 2006 18Ft Fenwick Williams Catboat Click to launch Larger Image The Apprenticeshop 2006 18Ft Fenwick Williams Catboat Click to launch Larger Image The Apprenticeshop 2006 18Ft Fenwick Williams Catboat Click to launch Larger Image The Apprenticeshop 2006 18Ft Fenwick Williams Catboat Click to launch Larger Image The Apprenticeshop 2006 18Ft Fenwick Williams Catboat Click to launch Larger Image














 



Show all sailboats for sale under: 15 20 25 30 35 40 45 50 55 60 70 80 (feet LOA) | Multihulls: Catamarans Trimarans