35' Custom Geerd Hendel Raised-Deck Cutter

1959 Custom Geerd Hendel Raised-Deck Cutter "Janet A" located in Savannah, Georgia, United States. 35' (10.67 Meters) LOA, 10' 6'' beam, 6' draft, wood hull.

Notable features include Cutter / Antique and Classics, Sail, Used, Electric, Wood Hull, 2020 Refit, Electric Engine, Quality Materials. Introducing Janet A, a 1959 Geerd Hendel 35' Mahogany on Oak with Teak Raised-Deck Cutter. This classic vessel, originally Lady Joan, was built by the Morse Boatbuilding Co. of Thomaston, Maine, and featured in WoodenBoat Magazine.

Details are offered in good faith; buyer should verify all information and condition through inspection or survey.

Contact Engel & Volkers Yachting for details and showing availability.

Forward cabin with comfortable v-berth
Enclosed head to port with a hanging locker to starboard
Main salon with port and starboard settee berths
Navigation station to starboard, adjacent to companionway
Galley to port with gimbaled range, ice chest, and storage
Abundant cabinetry and lockers for provisions and gear
Dropped and refastened ballast keel
Replaced/reinforced stringer and shelf beams
Renewed deck beams as needed
Replaced or sistered multiple frames
Refastened entire hull with larger silicon-bronze screws
Replaced topside planking and hood ends where required
Installed new butt plates
Installed operable bronze portholes in place of original fixed lights
Installed redesigned butterfly skylight
Replaced stem
Replaced king plank, rebuilt foredeck
Repaired/reinstalled bowsprit and covering boards
Rebuilt chainplates with 2(2x1/4) sandwiched bronze
Applied red lead to all new wood and hull interior
Installed new rudder with bronze hardware and extended shaft
Installed Dickinson fireplace heater
Rebuilt companionway bulkhead, hatch, and chain locker
Installed 144V DC electric auxiliary motor and wired new 12V main panel
Installed bonding circuit, replaced fore and aft bulwarks
Stored under cover; hull refinished (sides, top, bottom)
Installed galvanic isolator
Installed holding tank and pump-out system