23' Tremolino T-Gull 23
|
Year
|
Length
|
Beam
|
Draft
|
Location
|
Price
|
|
1997
|
23'
|
19'
|
4'
|
Colorado
|
$18,000
|
 |
Description: |
A very rare, well maintained, factory-built, 1997 Dick Newick designed folding trimaran. One man mast raising, opening of amas, and sailing with 30-40 minutes setup time. This Tremolino folding/swing wing trimaran is in very good condition and has recently had numerous upgrades to modernize the vessel its ready to sail.
Boat has been stored on the trailer, covered, and launched for each sail at marina, so no extra wear from being on dock or mooring. Most of its life was sailed on a freshwater lake, I recently sailed her in the Pacific Northwest but have washed the boat and trailer of all salt water afterwards.
Asking price $18,000 (including delivery within 1,000 miles of Northern Colorado) |
Equipment: |
Specifications Length: 23' long Beam: 19' wide Beam for trailering: 8 (when amas pivoted in) Draft: 18" daggerboard up / 4' daggerboard down (with crush blocks)
Key features Rotating 27 Hobie RS mast Integrated a-frame mast raising system Main sail and jib, both built in 2017 and in excellent condition with recent servicing and reinforcement added by North
Sails Mainsail has three reefpoints and all the lines for it All control lines come to the back of the cockpit for easy solo sailing Two daggerboards, one standard size and another slightly shorter and lighter Daggerboard includes crush blocks to protect the trunk Fore and aft cabins with new wood bunks, room for 1 person in each cabin Large center cockpit with oversized seats 2 full length Floating foam seat cushions, black Sunbrella material 2 floating throwable cushions, black Sunbrella material Tiller and kickup rudder Ritchie comp compass Mesh spray defectors and trampolines Running and cabin lights (requires battery) Can be motored and docked with the Amas folded in 5 hp mercury with external gas can
Recent upgrades as of May 2026 All rigging was updated in May at a cost of over $5,000 including: New stainless steel standing rigging for the mast New stainless steel support rigging for the ama/akas New strap toggles and turnbuckles to put it all together New running rigging and control lines all around All bulkhead attachment points (4(4 in total) were fully cleaned, bolts checked, and resealed with marine grade sealant
Sail kit Main sail: Two additional reef points added to the main sail, and all new management lines included for slab reefing Jib: Completed minor service in June to reinforce the existing stitching around the suncover and to replace the attachment points at the head, tack, and clew Boom: Upgraded boom installed with multiple cleat points/cheek blocks installed for slab reefing Furler: New bearing in Jib roller furler
Electronics (Note: MMSI and AIS data will be flushed at sale) New electrical system installed (two separate control panels, ready for your solar and battery) Modern VHF installed with DSC (Standard Horizon Gx2410gps 25w Vhf W/Gps, Ais, N2k & Hailer new VHF antenna) Bidirectional AIS installed new AIS/GPS antenna) Bilge pump installed Solar passthrough included, ready for your panel New navigation lights (forward and rear)
Other New Rudder Craft kickup rudder Four new windows installed New wood bunks built for both cabins, original hanging bunks are also provided Four canvas bags for holding gear (three up front, one in rear) Minor cosmetic touchups made
Trailer An original EZ Loader Trailer with new aluminum bunkers and large V-shaped pedestal to support the boat while trailering New tires Bearings were fully serviced in June Includes a new mast holding system New submersible lights New spare tire with lug wrench Overall in excellent condition
Asking price $18,000 (including delivery within 1,000 miles of Northern Colorado) |
|
Location: Fort Collins, Colorado
|
|
L112713

|
9702143414
|
|
|
 |
|
Material
|
Hull
|
Type
|
Rigging
|
Cabins
|
Condition
|
|
fiberglass
|
monohull
|
racer/cruiser
|
fractional sloop
|
2
|
excellent
|
|
|


|